Setting up profiles on site (Step by step)

• Set up first peg on site.
• Measure 7.2m with tape. (8.2m: Start 1m from tape for accuracy)
• Place peg two.
• Measure 15.5m from peg two. (16.5m)
• Place peg three.
• Measure 7.2m from peg three. (8.2m)
• Place peg four.
• Measure 15.5m from peg four to peg one. (16.5m)

• Place three pegs per corner.
• Measure 1m from pegs one, two etc...
• Form a three-point 90 degree angle with profiles.
• Set up dumpy
• Adjust bubble to center.
• Use 8m tape measuse to find mark 110mm for concrete level (FFL).
• From (FFL) 110mm mark, use tape measure.
• Find horizontal line via dumpy on tape measure.
• Use the same measurement for all profiles i.e (931mm).
• Mark the FFL
• Set up batter boards and bracing for profiles.
• Set up string line for the first two profiles.
• Square up all four profiles with string line.
• Use 3,4,5 technique to confirm measurements/squaring of site.
• Confirm measurements of 7.2m, 15.5m and diagonal 17.091m. 
• Replace the four house site pegs to the final measurements from the string lines.
• Site is ready to be boxed for concrete.